HOW TO ADJUST The Carburetor on Ryobi 2 Cycle Cultivator
This may be the same as some Ryobi Grass Trimmers. Visit my channel for more repair videos; www.youtube.com
This may be the same as some Ryobi Grass Trimmers. Visit my channel for more repair videos; www.youtube.com
@donyboy73 Okay, thanks. I’ll take a look at it.
@1972FordF150 It’s not strange here to have a weedater engine, I see it all the time. I don’t like them though. Prefer 4 cycle engine with tillers.
@foreverwood1963 I know it isn’t those tillers are just weird in my opinion. And I prefer a craftsman 26 inch front tine tiller with a 5 HP Briggs I/C engine. ( it’s what we own )
good job thanks for the information.
i have one and it wont run at all
most 2 strokes do that that is normal
@1972FordF150
I prefer my 52 inch with the 351 ford V8
Top vid. Very well done thanks.
@goldsuzy hahahaha what ?
i got a ryobi trimmer with this same engine same carb and everything. sometimes it will idle fine, but wont rev up. other times it will rev up but it wont idle. the diaphrams are good and the screws are fine. i dont know what to do
@pivotboy63 check all the fuel lines and on the connectors
@donyboy73 the fuel lines are all brand new, i replaced them this morning
@pivotboy63 i would put in a new carb kit, have you tried adjusting the carb?
love your videos…. i have a poulan pro NON adjustable carb on my trimmer…
it is now adjustable thanks to an emery wheel on my BD rotary tool… the trimmer has NEVER run without 1/2 choke until it’s absolutely hot and now it runs like
it should WONDERFUL!!!!
its called a wiper sniper
so if I have the same problem but my carb has no adjustment screws what should I do?
@savagenomore put a new carb kit in it
Donyboy98, You should start a small engine class if you don’t already do so. You give such step by step instructions in which anyone could follow. Thanks for all your help. Keep up the great work.
Hi donyboy73,
Great video! I cleaned the carberator as you instructed, however after I started it up it ran full throttle! It seems that the governor arm is not pushing back on the throttle assembly to slow the engine speed down. The assembly and spring is all reconnected as before.,How does this governor arm work? is there something inside the crankcase that may have got disconnected? Your help is greatly appreciated. Thanks!
:nyan:
that dose that thing do??
*what dose that thing do?? sorry
These engines aren’t too bad, the carbs are the lousy part.
i have the same problem with my pocket bike engine, it is the same engine and carb as ur stand up scooter. i tried adjusting the mixture screw on the side of the carb, and now it won’t run, what do you sagest i do
sounds like it gets to little gas might be the jets